16 weeks ago

I pulled the car out of a field about 16 months ago. Here’s a build breakdown:
Sbc 350 bored .30 over
Hyperutectic pistons
Forged connecting rods
Cast crank
Aluminum cylinder heads (200cc intake, 76cc exhaust, 64cc combustion)
1.5 roller rocker arms
Comps thumpr cam
Double roller timing chain
Hei distributor
High rise intake
650cfm Holley carb w nitrous plate
Makes 450 w/out nitrous. (I’ll throw in the 20 lb nitrous bottle, I never sprayed though)
It also has new carpet although it doesn’t fit very well. And a nice floor shifter, with a rose themed interior
The car has all new wiring, new fuel lines and tank, new 12 inch 4 piston caliper willwood disk brakes.
Car has a th400 transmission that was poorly rebuilt by some transmission shop in Cheyenne and a ford 9 inch rear end.
Parallel 4 link suspension
Cons:
Will need tie rod end on driver side and alignment before to long.
No exhaust, open headers. It will need shorter headers to make an exhaust work.
It has a really bad oil leak that neither myself, a Chevy dealership, or a speed shop could fix
Front brake lines have a leak I believe from the distribution block.
Transmission is wonky when it’s cold, when you first start moving.
Lifters will need replaced again.
It would be a fairly easy winter project considering it does run and drive.
Will come with a few extra parts, all trim/ chrome and stock heater box.
It’s the only one I’ve ever seen on the road.
NO RUST!
Located in Wyoming. Price is obo. Need it gone. Make an offer